Barium Titanate-reinforced Acrylonitrile-Butadiene Rubber: Synergy Effect of Carbon-based Secondary Filler

Acrylonitrile rubber(NBR) composites filled with barium titanate(BT) were prepared using an internal mixer and a two-roll mill. Also, a secondary filler, namely carbon nanotubes(CNT), was added in order to find a potential synergistic blend ratio of BT and CNT. The cure characteristics, tensile and dielectric properties(dielectric constant and dielectric loss) of the composites were determined. It was found that NBR/BT composites with CNT secondary filler, at a proper BT:CNT ratio, exhibited shorter scorch time(t_(s1)) and cure time(t_(c90)) together with superior tensile properties and reinforcement efficiency, relative to the one with only the primary filler. In addition, the NBR/BT-CNT composite with 80 phr BT and 1-2 phr CNT had dielectric constant of 100-500, dielectric loss of 12-100 and electrical conductivity below 10~(-4) S/m together with high thermal stability. Thus, with a proper BT:CNT mix and filler loading, we can produce mechanically superior rubber composites that are easy to process and low-cost, for flexible dielectric materials application.     

Preparation of Low-dielectric Permittivity Polyimide Resins with High Surface Activity from Chemically Bonded Hyperbranched Polysiloxane

Thermosetting resin matrix is the key component of advanced wave-transparent composites,where low dielectric constant,excellent processability,high thermal stability,as well as good bonding ability are required for resins.Herein,we prepared a series of phenylethynyl terminated polyimide(PI)resins by grafting amine-functionalized hyperbranched polysiloxane(HBPSi)to PI chains during the in situ polymerization.The effects of HBPSi on the processability of oligomers,molecular packing,thermal stability,dielectric property and bonding ability to reinforce Kevlar fibers of the cured PI/HBPSi composite resins have been examined in detail.The dielectric constants of the cured composite resins were greatly reduced from 3.29 to 2.19 without compromising its processability and thermal stability.Meanwhile,the 10 wt％HBPSi-containing PI resin demonstrated better bonding ability to reinforce fibers with the interfacial shear strength(IFSS)of 37.64 MPa,compared with that of neat PI-6 matrix(27.34 MPa),and better adhesion to metal with the lap shear strength of 10.48 MPa,50％higher than that of neat resin PI-6(6.98 MPa).These resultant PI/HBPSi composite resins exhibit excellent comprehensive properties,indicating their great potential as low-dielectric constant resin matrix in radar radome.     

DCE-MRI定量参数对子宫内膜癌的诊断价值及与临床病理因素的相关性

本文选取了子宫内膜癌患者108例作为观察组,另选取子宫内膜良性病变患者105例作为对照组,均行DCE-MRI检查后发现,观察组容量转移常数(K trans)、速率常数(K ep)、血管外细胞外间隙容积比值(V e)高于对照组(P<0.05);K trans、K ep、V e值联合诊断子宫内膜癌的曲线下面积(AUC)为0.841;K trans、K ep、V e值与临床分期、肌层浸润程度呈正相关,与分化程度呈负相关(P<0.05)。本研究结果提示DCE-MRI定量参数对子宫内膜癌具有一定鉴别诊断价值,有助于进一步区分子宫内膜癌患者肌层浸润程度、临床分期、分化程度。     

Unexpected Radical Telomerisation of Vinylidene Fluoride with 2-Mercaptoethanol

The radical telomerisation of vinylidene fluoride (VDF) with 2-mercaptoethanol as chain transfer agent (CTA) was studied to synthesise fluorinated telomers which bear a hydroxy end-group, such as H(VDF)_nS(CH₂)₂OH, under thermal (di-tert-butyl peroxide as the initiator) or photochemical initiations. A careful structural study of a typical H-VDF-S(CH₂)₂OH telomer was performed by ¹H and ¹⁹F NMR spectroscopy. These analytical methods allowed us to explore the selective addition of the thiyl radical onto the hydrogenated side of VDF, and the telomer containing one VDF unit was obtained selectively. Surprisingly, for higher [VDF]_o initial concentrations, a monoadduct telomer was produced as well as PVDF homopolymer. This feature was related to the fast consumption of the CTA. The kinetics of radical telomerisation led to a quite high transfer constant of the CTA (40 at 140 °C) that evidences the formation of a monoadduct as the only telomer formed.     

Tailoring the dielectric properties and energy storage density of 1−x(0.94NaNbO3−0.06SZ)−xBi2O3 through substitution strategy

Energy storage using dielectric capacitors is a growing area of research and development. However, designing a highly performing dielectric capacitor is still a challenge. Despite the excellent results achieved in lead-based dielectrics, lead-free substitutes are essential because of the environmental concerns associated with lead-based products. The lead-free 1?x (0.94NaNbO₃? 0.06SrZrO₃)+ x Bi₂O₃ ceramics abbreviated NNSZ + xB for x = 0.0, 0.05, 0.1, 0.15, and 0.20 was fabricated via solid-state reaction. A recoverable energy density of 2.93 J cm?³ was obtained for NNSZ+0.1B, associated with high thermal stability (25–130 °C), excellent cycling (N = 10⁵), and high efficiency (η) of 83.5%. Moreover, the introduction of Bi₂O₃ significantly improved the electrical insulation (?_r at 1 kHz = 1608 and tan δ = 0.0038) and breakdown strength (380 kVcm?¹) of NNSZ+0.1B by minimizing the formation of sodium, bismuth, and oxygen vacancies. The results obtained in this study provide a benchmark for further investigations on NaNbO₃-based ceramics. More importantly, this study suggests that NNSZ + xB ceramics can be used in pulsed power technology.     

Thermodynamic studies on protonation constant of adenosine and guanosine at different temperatures and ionic strengths

Stepwise protonation constants of two purine nucleosides (adenosine and guanosine) were determined at different temperatures (293.15 to 308.15) and various ionic strengths (0.101 to 3.503 mol · kg⁻¹ NaClO₄) using a combination of potentiometric and spectrophotometric method. The thermodynamic parameters (i.e. enthalpy change, ΔH, and entropy change, ΔS) of the protonations were calculated at different temperatures using van’t Hoff and virial equations. The dependence of the protonation constant on ionic strength is modeled by a Debye–Hückel type equation and discussed. Finally, the protonation constants of the nucleosides and the enthalpy change of protonations were determined at zero ionic strength.     

Anharmonic Effect of the Unimolecular Isomerization/Decomposition of Benzyne

The anharmonic and harmonic rate constants were calculated for the unimolecular decomposition of o‐benzyne, the isomerization of o‐benzyne to m‐benzyne, the isomerization of m‐benzyne to p‐benzyne and unimolecular decomposition of p‐benzyne by using the Rice–Ramsperger–Kassel–Marcus (RRKM) theory respectively, in the canonical and microcanonical systems. The geometry and the vibrational frequencies were calculated by MP2 and B3LYP methods with 6‐311G(d,p) basis set and the barrier energies were corrected using CBS‐QB3 theory. The anharmonic effect on the reactions was also examined. Comparison of results for the decompositions of benzyne indicate that both in microcanonical and canonical cases, the anharmonic effect on the decomposition of the o‐C₆H₄ and p‐C₆H₄ are significant, while the anharmonic effect on the two isomerizations are not pronounced.     

介质阻挡放电甲醇脱氢偶联一步合成乙二醇反应中氢气的催化作用

利用原位发射光谱表征和在线色谱分析,研究了甲醇介质阻挡放电脱氢偶联一步合成乙二醇反应中氢气的催化作用,考察了放电频率、甲醇和氢气进料量以及反应压力的影响.结果表明,在介质阻挡放电产生的非平衡等离子体中,H2不但能显著提高甲醇转化率,而且能显著提高乙二醇的选择性.在300°C,0.1 MPa,反应器注入功率为11 W,放电频率为12.0 k Hz,甲醇气体进料量为11.1 m L/min,氢气进料量为80–180 m L/min的条件下,甲醇转化率接近30%,乙二醇选择性大于75%.乙二醇收率与激发态氢原子的Hα谱线强度之间存在同增同减关系.由此推测,氢原子是起催化作用的活性氢物种.活性氢物种的生成途径是:基态氢分子通过与电子碰撞变成激发态,激发态氢分子通过第一激发态氢自动解离为基态氢原子.放电反应条件通过影响氢分子解离来影响氢气的催化作用.氢气在非平衡等离子体中显示的催化作用有可能为开辟新的化学合成途径提供重要机遇.     

环烷酸对油水界面膜流变性质的影响研究

研究了环烷酸对油水界面膜界面张力、弹性模量、损耗模量以及界面膜破裂速率常数的影响,同时对环烷酸与沥青质之间的相互作用进行了测定。结果表明,环烷酸使得原油油水界面张力下降;弹性模量随着环烷酸加量以及振荡频率的增加都分别逐渐增大,并且最终都趋于平衡;在任何振荡频率值时,损耗模量都随着环烷酸加量先增大后减小;当环烷酸加量增加时,界面膜破裂速率常数降低。环烷酸与沥青质之间存在相互作用,随着环烷酸加量的增加,其对沥青质界面膜弹性模量的影响与对原油界面膜弹性模量的影响相似,表明环烷酸主要是通过与沥青质相互作用而促进乳状液稳定性的。     

一元强碱滴定一元弱酸溶液的林邦滴定曲线方程及其应用

以林邦副反应思想为基础,用质子条件式PBE、物料平衡式MBE、滴定分数和条件稳定常数等知识推导出一元强碱滴定一元弱酸溶液的林邦滴定曲线方程,并用滴定曲线方程讨论了滴定开始至化学计量点时任意一点p H的计算。